77Dmax's latest activity
-
777Dmax replied to the thread First real drive! Not tragic but not good. I think I need carb advice..You probably have a vacuum leak somewhere.
-
777Dmax replied to the thread WebMonkey's latest melt down, poor ol' me, hissy fit. (yes, I'm WebMonkey).45 Fahrenheit? Thats where I heat my garage at in the winter.
-
777Dmax replied to the thread Repeated stalling.Check the grounds at the t-stat housing and clean the throttle blades. Also clean the egr valve. It's probably stuck open some.
-
777Dmax replied to the thread Changing gear ratios: opinions/suggestions wanted!!.Twenty-five years ago if you would have told me anyone was buying a 3/4 ton truck just to commute with I would have laughed in your...
-
777Dmax replied to the thread No driver's side rear turn signal or brake light, because no power at bulkhead.If you have a tilt column the wire might be broken at the swivel point. Usually there isn't enough space to repair it though. A new...
-
777Dmax replied to the thread No driver's side rear turn signal or brake light, because no power at bulkhead.You probably need a turn signal switch. There are two dogs in the switch that move (literally) between the brake and turn signal input...
-
777Dmax replied to the thread Big block running hot. Can’t figure out the issue.I gotcha. They would have to put the ribbed side to a smooth pulley or vice versa, and that would be hard not to notice. Its a...
-
777Dmax replied to the thread Big block running hot. Can’t figure out the issue.In a serp setup any pulley that is turned by the smooth side of the belt is spinning opposite of the crank, any pulley that is spun by...
-
777Dmax replied to the thread Changing gear ratios: opinions/suggestions wanted!!.I wouldn't put a 700 in a 3/4 ton truck, that's a step backwards.
-
777Dmax replied to the thread Big block running hot. Can’t figure out the issue.It's probably not the cause of your ovwrheat issue based on your symptoms, but you should check your total timing and power time it. If...
-
777Dmax replied to the thread Anyone running Wilwood clutch master.I have a wilwood 5/8 master in the hotrod. Works great, probably 15k miles and over 300 passes at the track.
-
777Dmax replied to the thread Big block running hot. Can’t figure out the issue.What are your cruise AFR and total timing specs?
-
777Dmax replied to the thread Thread sealant on header bolts?.The oil leak is running down from the valve cover.
-
777Dmax replied to the thread Olds 350 diesel to sbc swap.An olds 455 would have been a bolt in swap! Cap the lines until you're ready to drain and hook them up..
-
777Dmax replied to the thread Anyone else have this "Turbo Diesel" plaque?.Thats NA.
