77Dmax's latest activity
-
777Dmax replied to the thread Changing gear ratios: opinions/suggestions wanted!!.A 4l80e with a standalone computer would be pretty slick here, otherwise I would go 4.10s.
-
777Dmax replied to the thread never jerk a stuck truck with a chain.I must be the only one here with farm experience. Chains are the only thing that will move a 30k tractor
-
777Dmax replied to the thread Shop heater.I have a 40x40 and will be putting in a mini split next year. I wanted it this year but put the money elsewhere.
-
777Dmax replied to the thread Recommendations while tearing down for valve job?.Having done this job several times before, I recommend pulling the motor. It's only a few more bolts, and working bent over the...
-
777Dmax replied to the thread big block starter replacement.I have mine rebuilt. Usually costs around 50 bucks and done by the afternoon.
-
777Dmax replied to the thread Clutch cover and flywheel damaged out of the box?.I would run that and not think twice about it.
-
777Dmax replied to the thread Coolant Hose Popped Off the Thermostat.I wouldn't over think this one. Replacing radiator hoses used to be very common. I would replace the hose and move on.
-
777Dmax replied to the thread Fuel economy C10 with carb.If you haven't tuned the new edelbrock you are leaving a lot of power and mileage on the table. Also timing with vacuum advance will...
-
777Dmax replied to the thread New build 454 and the wife hates the exhaust smell.Are the floors/quarters rotted out?
-
777Dmax replied to the thread Installing a New Exhaust System Including Headers.Summit branded parts are usually very poor quality. I have had luck using a ratchet strap to pull on headers to move them around. Just...
-
777Dmax replied to the thread Finally got a new mig welder.I find the cheap ones do the bigger stuff ok but make a mess of anything smaller than 12-14 gauge. You really need a good welder for...
-
777Dmax replied to the thread Surface rust. What are the best practices?.I would stand that bed up and sandblast it. It will clean up fast. I wouldn't worry about warping it. That rust will blown right off.
-
777Dmax replied to the thread Press-in rocker arm studs migrating up..If the studs were pulling out there would definitely be some new valvetrain noise along with it. I believe you are seeing the effects of...
