beady
Latest activity Postings About
-
-
beady replied to the thread 1987 454 TBI stalls at idle after a short time.Thanks Bill, that was super helpful info, I really appreciate you taking the time to post those hints. The install went well and the... -
beady replied to the thread 1987 454 TBI stalls at idle after a short time.That’s super helpful info on the WINALDL, thanks! Cable should be here Thursday it says. It’s one of my son’s old laptops, I think he...
-
beady replied to the thread 1987 454 TBI stalls at idle after a short time.Thanks Bill, Sorry, for the long post below: When I said I don’t need “timing” in that post, I had typed “tuning” and it got...
-
beady reacted to Bill USN-1's post in the thread 1987 454 TBI stalls at idle after a short time with
Like.
For all of you, here's a couple basics. The ECM connectors can built up light corrosion and cause intermittent issues. Unplug the ECM... -
beady reacted to Bill USN-1's post in the thread 1987 454 TBI stalls at idle after a short time with Like.
The cable comes with a CD or optional thumb drive full of free software. For the C3 ECM like your 1227747, I prefer to use winaldl. Much...
-
beady replied to the thread 1987 454 TBI stalls at idle after a short time.I ordered a cable. That’s my concern too, that it’s going to be a pita to get working without downloading a bunch of different...
-
beady replied to the thread 1987 454 TBI stalls at idle after a short time.I had an OTC scanner that would show you data. But not graphically, and it got stolen. I ordered an ALDL usb cable yesterday...
-
beady reacted to Bill USN-1's post in the thread 1987 454 TBI stalls at idle after a short time with Like.
Here's my reply to you msg on binderplanet.com ____________________________________ Best to post in the injection forum then PM...
-
beady replied to the thread 1987 454 TBI stalls at idle after a short time.Well…. I went to check timing (it was about 20 degrees btdc) and I pulled the timing connector wire to check base timing and the engine...
-
-
beady replied to the thread 1987 454 TBI stalls at idle after a short time.Thanks for that. However, since I complained the truck has been running normally, go figure. I’ve done probably 8 dead cold to...
-
beady replied to the thread 1987 454 TBI stalls at idle after a short time.Thanks for the detailed reply. I had a scanner that would give ALDL live data until about a week ago. My son borrowed it for his...
-
beady reacted to fast 99's post in the thread 1987 454 TBI stalls at idle after a short time with Like.
FYI, TBI primarily uses MAP for fuel trim. O2 sensor only effects trim after reaching operating temp and usually will not stay hot...
-
beady reacted to Vbb199's post in the thread 1987 454 TBI stalls at idle after a short time with Like.
If you had a means to scan the obd1 interface, you could check manifold pressure.... but since those all seem to be gone from the...
-
beady replied to the thread 1987 454 TBI stalls at idle after a short time.MAP sensor is a couple months old, a couple hundred miles old, tops. I haven’t tried spraying starting fluid around intake to check for...
-
Hello again, I have this new to me 1987 454 TBI suburban that I’ve been chasing problems down in. Today’s issue is stalling after a few...
-
-
Loading…
-
Loading…
