-
-
Old Guy Bill reacted to Bextreme04's post in the thread Lost Two Gen 3 LS Engines in my 1986 C10 2WD with
Like.
I'm just going to point out that 130psi on a 2002 5.3 is not OK compression. That should be 150-185psi AT LEAST. You need to verify... -
It makes too much sense for people asking for help to give all the relevant information to make it easier for other members (members who...
-
Diagnose before changing parts. Your chances of getting a new good fuel pump is maybe 50/50. Check fuel pump pressure and volume. And...
-
I rotate the engine till the rod is in as far as possible, put some grease on the pump rod so that it doesn't slip out, double check and...
-
The short one won't hold it you remove the short one put in a long one,change the pump remove the long one,put the short one back.
-
They bend easier and more often than you think. At some point in its life someone probably changed the pump using a Long bolt through...
-
Old Guy Bill reacted to EvilGenius's post in the thread ‘83 K5 350/4wd: aftermarket oil psi switch/sender/choke heater wiring question w/pics and schematic with Like.
I think your understanding of that circuit is a little backwards. The reason the choke is wired with the oil pressure sensor is to...
-
I'd have a local builder build it and install it,that way if there's a problem,it's their problem,not your problem. I would not pay...
-
Old Guy Bill reacted to SquareRoot's post in the thread Modified engine crewcab gas mileage? with Like.
New guy asking about fuel milage... :laughing1: 10....like everybody else.
-
Hey Rob, I actually work for AMD, hopefully I can shed some light. Throw some pictures up if you have that, pics always help. The "drop...
-
Old Guy Bill reacted to Bloodhound1981's post in the thread Lost Two Gen 3 LS Engines in my 1986 C10 2WD with Haha.
Small block swap it. Sorry, had to.
-
Old Guy Bill reacted to Ricko1966's post in the thread Lost Two Gen 3 LS Engines in my 1986 C10 2WD with Like.
Just so everyone knows,they don't necessarily blow a hole in the top they often times melt and deform the top ring land. Or detonate and...
-
Old Guy Bill reacted to legopnuematic's post in the thread Will a 8.5 Camaro 10 bolt axle fit in a 1981 squarebody? with Like.
A Camaro should be a 5x4.75 bolt pattern, a 2wd 1/2 ton is 5x5 bolt pattern. Meaning you need different wheels for the rear, or change...
-
Old Guy Bill reacted to Strick's post in the thread Will a 8.5 Camaro 10 bolt axle fit in a 1981 squarebody? with Like.
The length overall is different as well as the spring perches being below the tubes instead of above. There are no shock saddle/perches...
-
Old Guy Bill reacted to Strick's post in the thread What have you done to your square lately?? with Like.
Many thanks. Most of my car buddies have really liked it since I got it. A few of them have remarked that I've "switched over" and some...
-
-
Loading…
-
Loading…
