mibars
Latest activity Postings About
-
-
mibars replied to the thread Suburban Rear Cargo leaks.Resurrecting the old thread as after a car wash I found a small pond splashing around in a spare tire well. Are there any known working... -
mibars replied to the thread 700R4 Information Thread.Maybe an unusual question, but do you know what's the volume of fluid pumped by the oil pump in this transmissions? It's just out of my...
-
Just the arm rest pad.
-
mibars replied to the thread Blazer rear seat arm rests.Do you mean a whole rear bench or just the armrest foam?
-
You can swap in a 4l80 far cheaper than that, and gain the lockup converter.
-
Run it through the radiator then to the ext cooler. You're giving up a lot of heat exchange by not including the internal cooler in the...
-
mibars replied to the thread T-tops for C10.Would be interesting to see a Blazer with such setup!
-
For sure, but great :D
-
I'd put 2 kits on a crew cab, lol. That is pretty cool though, it's not something I've seen. I too would buy the NOS kit just to have...
-
I’ve never seen those… I’ll bet they are a leak nightmare..
-
Assuming your gauge is accurate, I'd say yes. Sounds like its hanging in the open position. It should open and close within 10 degrees...
-
If you can't see any active leaks, you may have a problem with the master cylinder. Either defective or needs bleeding. Did they ever...
-
mibars replied to the thread Oil Pressure Drops After High RPM.It's a recommended weight for 1990 350 TBI, So at least in 1990 they were designed for that oil weight It looks like there is way below...
-
mibars replied to the thread Brought home my first square body. 1980 Silverado C10. Utah.As Ali said there are plenty of shows and YT channels focused on reviving old junk. Stay Tuned did a straight six Square body recently...
-
mibars reacted to ali_c20's post in the thread Brought home my first square body. 1980 Silverado C10. Utah with
Like.
Only Roadkill is on Motortrend. All the others are independent on Youtube.
-
-
Loading…
-
Loading…
