Drauka99
Latest activity Postings About
-
-
Drauka99 replied to the thread Help working with wheel arch replacement.I had to replace one arch trim on my build and the LMC one fit with just a little massaging like yours. I started in the middle and... -
Drauka99 replied to the thread Looking At A 2005 Z71 4x4.Only issue I have ever had with my 04 is the AC/Heater is the weakest system I have had in a GM vehicle. my 04 Blazer and 97 GMC, 2001...
-
So that being an '05 ECSB Z71, it could be an L33 truck. Get a picture of the RPO sheet if you can. L33 was the Hi-Po 5.3 with an...
-
Drauka99 replied to the thread Looking At A 2005 Z71 4x4.oh yeah and the jamb door handle to open the rear door snapped right off when opening the door a while back... was easier and cheaper...
-
Drauka99 replied to the thread Looking At A 2005 Z71 4x4.I have a 04 z71 extended cab, Had it since 07 and it had 36k miles on it when i bought it, 175k now. Wheel bearings went out around...
-
Drauka99 replied to the thread Thinking about a new smaller steering wheel, comfort grip or forever sharp?.Saw a tip somewhere else that said to use the "tub'o'towels" (I think that's what they are called) to clean up the old steering...
-
Drauka99 replied to the thread What have you done to your square lately??.Threw the truck on the road and cruised her to family Christmas gathering and home with no issues. Bonus was the drive home after dark…...
-
Drauka99 replied to the thread LS freeze plug issue.If I guessed I’d say rust pitting from a slow leak for a long time before it got bad enough to be discovered.
-
Drauka99 replied to the thread What have you done to your square lately??.Took the truck to town on Sunday for a shake down run. Gas tank filled and ran it home. Took care of a few more small details and...
-
-
Drauka99 replied to the thread LS freeze plug issue.know some who when reinstalling a freeze plug in situations like that us a thin application of rtv on the rim of the new freeze plug to...
-
Drauka99 replied to the thread What new tools have you got lately?.Worked on a job years ago where they had to run a new large water service for the fire suppression system on the building. The water...
-
Drauka99 replied to the thread 04 LM7 into 87 K5.The VSS in the trans (before the Tcase) will read the same speed regardless of the T-case being in high or low. The ECM(PCM) uses VSS...
-
Drauka99 replied to the thread New Process A833 4speed w/ OD MY6 MM7.Only thing I've seen mentioned is the bushing for the input (or output) shaft wear out and the case being aluminum they get wore badly...
-
Drauka99 replied to the thread What new tools have you got lately?.Don't know if this counts but my workshop build gets stated Wednesday. Hired a group to put up a roof. 40'x60', of that ill have a...
-
Drauka99 replied to the thread What have you done to your square lately??.I'm getting close to my project being back on the road. Tag acquired. I have 90% of the interior back in it and the exterior is...
-
-
Loading…
-
Loading…
