D
Dlefler
Latest activity Postings About
-
-
DDlefler replied to the thread Fender adjustment.Thank you! I appreciate it
-
DShared a link to a Great video on how to aline and gap body panels on a square. Hope this helps
-
DCan I make adjustments on my fenders by just loosening the bolts or do I have to take the whole thing off?
-
D73-91 K10 K5 Dana 44 or 10 bolt will bolt right in. Even if its an 8 lug, your 6 lug will interchange and do the swap. So buy whatever...
-
DDlefler replied to the thread Rebuilding rear axle DIY?.Thank you
-
DIf you're very mechanically inclined, you can do it. If not, it's probably best left to pros. I've been wrenching my whole life and just...
-
DDlefler replied to the thread Rebuilding rear axle DIY?.You are thinking that somebody changed out the yoke? That very well could be as everything on this truck has changed and hacked. Is it...
-
DSpider gears won't move the pinion yoke forward. When you start taking the diff apart heat the area at the cross shaft retainer...
-
DI'd inspect the spider gears for wear before doing a full tear down. That can be all of your play and a much easier fix. Especially if...
-
DYour current trans is still working properly? My advise would be to stop right there. Crud in the trans pan is normal, and does not mean...
-
DDlefler replied to the thread Buying a rebuilt transmission th350.Thank you, very informative I did pass on buying that transmission it came with a 203 transfer case with like you just told me will not...
-
DAll turbo 350 are 27 spline output. Check how far the output shaft sticks out. 2.5 inches is correct for the 208. The 203 and 205 are...
-
Dhahaha, but wait, you can't put a Th350 behind a Big Block. Just can't do it. It won't hold up. :lol: Yeah well, I call BS too. Back in...
-
DI built mine with an ATSG 350 book, and a HP books Rebuilding your Turbo-Hydro 350, Wished I had had Nick back then. Listen to the...
-
DNot a problem. That's what we do here. Help others, get help from others, share ideas and get opinions.
-
-
Loading…
-
Loading…
