-
-
CI know 2 guys who make a living sandblasting and spraying semi trailer frames. Both use POR15 and both told me to use it as a primer and...
-
CCalSgt replied to the thread Eastwood Versus POR15.If you’re blasting you shouldn’t need any special “prep” product, paint will stick to the rough texture left from blasting. I don’t...
-
CI took mine to an upholstery shop because it had been covered before. Here's copy of a thread of my build, showing the speaker hole...
-
CCalSgt replied to the thread No accessories power.^^^^ Basically this There may be a bit of a compromise on the best position for the ignition switch. When its perfect each key...
-
CIgnition switch adjustment needed.
-
C81+ glass is a little thinner than 73-80. Use the corresponding year window guide to match the glass. I believe the belt line are the same.
-
CCalSgt replied to the thread 04 LM7 into 87 K5.When I did my 4L60E + 208 combo all of the information I found claimed the Dakota signal wasn’t good enough for the factory PCM to shift...
-
-
CCalSgt replied to the thread Engine & transmission removal & reinstall general tips.^^^ I’m a fan of the accessory bolts in the heads and a chain
-
CCalSgt reacted to tsgs84's post in the thread Engine & transmission removal & reinstall general tips with
Like.
I always use a front head accessory bolt and a rear head accessory bolt on the opposite side with an adjustable load leveler attached to... -
CCalSgt reacted to Keith Seymore's post in the thread FB Marketplace find near Austin, Texas: 5 aluminum K10 wheels $50 with Like.
I see my work here is done. It was changed as a cost savings. Forged = RPO PH7 Cast = RPO N90 I think the forged wheel will be...
-
CCalSgt reacted to ali_c20's post in the thread New wiring dosnt do anything when key is on. with Like.
I vote for ground. Have you temporary grounded your exterior lights to the chassis/ body ? Ground connection from chassis/body to...
-
CCalSgt replied to the thread Diesel Dash Light and Socket.CA is pretty messed up but at least “smog” is sellers responsibility…. MIL = failed smog
-
CYou holding that lens reminds me of a customer fail inspection due to no MIL on KOEO. Hooked scanner up & there were plenty of DTC's...
-
CThats the one. I have a plan B and C if I dont come up with one.....just wunnerin if one was floating around out there.
-
CCalSgt replied to the thread Diesel Dash Light and Socket.I dug this one up today let me know if the other one falls through. I don’t have the bulb sockets though
-
-
-
Loading…
-
Loading…
