1lejohn's latest activity
-
New O.E means nothing at this point,different engine,different carbureator,different intake,camshaft,etc. put it on manifold vacuum,you... -
1lejohn reacted to nvrenuf's post in the thread What have you done to your square lately?? with
Like.
I finally worked up the nerve to cut my original doors. I really like my tube doors but I'm liking this look more. -
If the lines at the block are still good for a few inches,you could flare them use couplers and make new hardlines,just like making...
-
Check vacuum and compression,as well check for vacuum leaks,use carb cleaner around the manifold base. Hook a vacuum gauge to the...
-
Turn the switch over. Drink beer. Carry on.
-
Edelbrock carbs seem to go dry very quickly. Mine does the same as yours- have to crank it to get fuel up to the carb then fires right...
-
1lejohn replied to the thread Update on my Ignition Module failure!.https://www.summitracing.com/parts/msd-85001
-
1lejohn replied to the thread I am joining the club with a new to me 1977 GMC C15.Clean old truck. Good luck on the project.
-
1lejohn reacted to ali_c20's post in the thread New steering pump and still leaks power steering fluid. Do I need a different pump or Lucas stop leak? with Like.
Had leaks from the cap 2 times and it was both times my fault. Not bleed the entire air out of the system. Overfilled.
-
I don't buy distributors I use genuine GM,AC Delco gold,or NAPA premium modules. I reuse/ rebuild,find new old stock, as much as...
-
I had the same problems until i put a msd distributor in my 84 and been good for years, Probably just jinxed myself lol
-
1lejohn replied to the thread Update on my Ignition Module failure!.I would get rid of the modules and run an MSD box. The kit costs about what the GM dizzy costs. No more module's, better spark power...
-
Is it reading the fuel level from the correct tank, but drawing from the other tank? Switch on right, drawing from left, showing fuel...
-
1lejohn replied to the thread Dual tank reads backwards.I would think that the wiring going to the new switch is backwards, (reversed), or the wiring going to the valve is wrong. It could be...
-
They do make really nice rims and caps
