1lejohn's latest activity
-
Firestone still makes a 9.50-16.5" tire. About $199 each on amazon, but it basically a highway tread. I attached a link. My K30 had... -
1lejohn reacted to ChuckN's post in the thread What have you done to your square lately?? with
Like.
First drive, flawless. Glad I did those inner fenders, not a single rub. -
1lejohn reacted to Rustisbest's post in the thread What have you done to your square lately?? with Like.
Got my x-pipe fixed last week so its off the driveshaft, drove it a few times to break in the gears. Couldn't resist testing the...
-
No questions, just showing what I'm up to. I replaced the gaskets on these valve covers back in the early 90s, so no shock that the...
-
1lejohn reacted to cmichels83's post in the thread Building a new motor for my 79 C10 - would love some advice! with Like.
Currently have an engine at a machine shop as well, so just went through the process of choosing parts for low end power for towing and...
-
1lejohn reacted to SquareRoot's post in the thread Borgeson K10 Quick Ratio Price Drop !!! with Haha.
Curious how much shipping would be from Uranus...:laughing1:
-
I went with the Eaton 912A556 Detroit Truetrac 8.5" 28 Spline Differential with 10 Bolt for my '85 K5, and I also replaced the ring and...
-
1lejohn replied to the thread Just picked up an LT4 swapped '86 C10.Welcome. Clean looking truck.
-
Hey y'all, I just picked up a new to me '86 C10 Silverado with a '96 LT4 swap. Working through some issues with it, but the intent is...
-
1lejohn replied to the thread Building a new motor for my 79 C10 - would love some advice!.Here is an easy way to make sure the parts all match. https://www.summitracing.com/parts/edl-2038/make/chevrolet It's a little pricey...
-
I'm going to rebuild and beef up my 350 sbc. It's the og engine /era correct engine so i want to keep it in the truck as lots of other...
-
1lejohn reacted to legopnuematic's post in the thread Filling small holes without welding with Like.
I have not done the soldering method, but have used JB weld to fill over a hole or two and have had reasonable success. Short strand...
-
1lejohn replied to the thread Rebuild or Swap?.Summit has some good kits. If the 350 block is good I would order a 383 kit and go from there. I guess it depends on your budget and how...
-
1lejohn reacted to Powerhouse Ranch's post in the thread What have you done to your square lately?? with Like.
It is home and officially in the stable! Brother took it for a spin and it is gear LOWWWWWW. Apparently it’s an off road BEAST. I’ll be...
-
1lejohn replied to the thread Which A/C compressor do I have?.Make sure the vacuum line from the engine bay is connected to the AC control panel that's mounted in the dash. The default operation...
