-
-
legopnuematic reacted to Mr Clean's post in the thread What have you done to your square lately?? with
Like.
Mounted new sway bar brackets, and got the sway bar mounted. Cleanded up bumper brackets and mounting bolts. Mounted the front bumper... -
legopnuematic reacted to Mr Clean's post in the thread What new tools have you got lately? with Like.
Got a set of dimple dies. 45.00 bucks. From a seller in Katy, TX. 1/2, 3/4, 1 inch.
-
legopnuematic reacted to TotalyHucked's post in the thread Huck's daily - 2005 Z71 crewcab with Like.
Just watched a couple videos, that's a nifty tool! For $100-150, I'll probably pick one up. I even got my buddy to tune the trans in...
-
dunno! furthest back i can remember was the 60s in nebraska and dad had an extension cord run out to the driveway in the winter. watched...
-
I didn't read all 97 posts. Here's the deal and it's just simple math and physics. If you put a heater in the dip stick or stick one to...
-
legopnuematic replied to the thread Huck's daily - 2005 Z71 crewcab.The clamshell pullers are used on carrier bearings, if you are reusing a carrier, or on Dana axles they sometimes put the shims...
-
-
legopnuematic reacted to TotalyHucked's post in the thread Huck's daily - 2005 Z71 crewcab with Like.
All good tips, I really appreciate it. I do plan to deburr everything, I've read about that as well as checking backlash and runout on...
-
legopnuematic replied to the thread Engine Block Heater for SBC 350.Back when 6 volt vehicles were still mainline people would install 4 cell 8 volt batteries to give them a little extra cranking power...
-
legopnuematic reacted to brooksman9's post in the thread What have you done to your square lately?? with Like.
I hate sanding
-
@WFarm @TotalyHucked @Doppleganger You guys are tempting me to start down the rabbit hole! The bezel has dropped in price for my...
-
Hell i will share a story ABout 6 months ago we had a tractor trailer delivery at the shop, i think it was XPO logisitics... and they...
-
Its crazy it was sitting on the white line of the road... i got no idea how it didnt get hit lol
-
legopnuematic replied to the thread Huck's daily - 2005 Z71 crewcab.It’s not much, on the setup bearings I have made it has been from .0005 to .0015 I’ve had to hone out. Not much at all. Just a nice slip...
-
legopnuematic reacted to TotalyHucked's post in the thread Huck's daily - 2005 Z71 crewcab with Like.
Definitely appreciate the advice! I'd thought about that for the setup bearings too, we have a wheel cylinder hone at work. It just...
-
I remember when I was a kid me and my dad went to a hardware store over 45 miles away and when we got there and started walking away one...
-
-
Loading…
-
Loading…
